Use this guide to assist with the installation of your ADC-VDB770 video doorbell.
Button Behavior
Button light guide
| LED pattern | Description |
|---|---|
 Off | Power off |
 Blinking yellow | Camera power cycling |
 Solid red | No local or Internet connection |
 Blinking red | Power on, camera booting |
 Alternating red & green | Camera resetting to factory default |
 Solid green | Connected to Alarm.com |
 Blinking green | Local network connection |
 Blinking blue | WPS mode |
 Blinking white | Wi-Fi Access Point mode |
Button functions
Use this table for Video Doorbells with firmware version 2160 or later.
| Button push duration | LED pattern | On button release |
|---|---|---|
| 0-30s | Current State (no mode) | None |
| 30-35s | Blinking Blue | Enter WPS Mode |
| 35-40s | Blinking White | Enter AP Mode |
| 40-45s | Blinking Yellow | Power Cycle |
| 45-50s | Green/Red Alternating | Factory Reset |
| >50s | Current State (no mode) | None |
Use this table for Video Doorbells with firmware versions before 2160.
| Button push duration | LED pattern | On button release |
|---|---|---|
| 0-30s | No change (current state) | None |
| 30-45s | Blinking Blue | Enter WPS Mode |
| 45-60s | Blinking White | Enter AP Mode |
| 60-75s | Blinking Yellow | Power Cycle |
| >75s | Green/Red Alternating | Factory Reset |
Note: If the indoor chime is enabled for the device, holding down the button will trigger a single indoor chime immediately after being pressed. If desired, the indoor chime can be disabled through the Customer Website before pressing the button to initiate one of the above modes.
Troubleshooting
- If there are issues connecting the Video Doorbell to the account, power cycle the camera by holding down the doorbell button until the LED starts blinking yellow (~60-75s) and then releasing the button. After the device reboots, try connecting again.
- If issues persist, factory reset the Video Doorbell by pressing and holding the doorbell button until the LED starts blinking red and green (~75s). The device will reboot with factory defaults.
Important: If the device was previously installed to an Alarm.com account, it will need to be deleted before it can be installed again.